RSS

Whisky Jerky

A little Whisky can make anything taste better.  Jerky is no exception.  The flavor of charred Oak mixed with beef makes a jerky everyone loves.

Check out my original recipe – Homemade Ground Beef Jerky

DSCF0002

Ingredients:
1 lb Ground Beef – 90% lean or better
3 TBSP Whisky
2 TBSP A1 Sauce
1 tsp fresh ground Black Pepper
3/4 tsp Garlic Powder
3/4 tsp Onion Powder
3/4 tsp Table Salt
1/4 tsp Curing Salt

Directions:
First thing you need to do is to pour the Whisky and A1 into a small saucepan and mix to combine. Heat the mixture to below a simmer and allow to reduce approximately 80%, around 20 minutes, stirring very frequently. (Make sure to reduce fully or your jerky will turn out brittle.) Do not allow the sauce to burn to the bottom of the pan.
Next you need to mix the reduced sauce will all the remaining spices into a large bowl and stir together well.  Then add the ground beef into the sauce/seasoning mix bowl. Get in there with your hands and mix the meat and the sauce together very well. Mix a few minutes past when you think you’re done mixing. The more mixing, the better, it will extrude easier.

Jerky

Start piping some of the meat mixture into your extruder gun, you can see our gun in the picture above. Try not to allow any air bubbles to get in the works and mess up your jerky strips. Begin extruding approximately 6 inch strips onto the dehydrator grate trays. Allow a small amount of space in between the sticks. Do this until all the beef mixture is used up.

Extruding ground beef jerky

If the jerky strips are coming out in bits and spurts it means one of two things. Either your ground beef was too red and bloody (and extra moist), or that you did not reduce your sauce down far enough. The jerky should come out of the extruder gun easily. There’s not much you can do to fix the meat at this point so if it’s coming out poorly, just do the best you can with it.

DSCF0006

We dehydrate for 7-8 hours, rotating the trays every 2 hours, and checking for done-ness along the way. The time will vary depending on the temperature of your dehydrator. Our JerkyExpress only has an on and off setting, no actual temperature setting, but it runs at around 150 degrees. The jerky will feel slightly stiff when done. We like to allow the jerky about a day in the fridge before eating so the texture can firm up properly. Then you can store in the fridge or in a closed container in the pantry for 3-4 weeks, although most likely you’ll have eaten it all long before then. If you plan to store the jerky in the fridge, allow some time for it to warm up before eating, as it tastes much better warm than it does cold.

That’s it, how hard was that? I hope you like it! Enjoy!

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

 
%d bloggers like this: